Sanyo FWBP706FA Owner's Manual page 60

Problem
Cannot load a Blu-ray Disc™ (that
is stuck in loading mode and
cannot open the disc tray to eject
the disc.
Cannot read a USB memory stick.
Cannot play back photo files from
a disc.
Cannot find a photo file.
Cannot play back music files from
a disc.
Cannot find a music file.
Music files play choppy.
No audio signal from surround
system of the audio system.
Cannot connect to the Internet
although the connection test
passes.
Cannot connect to the network.
Cannot use "Auto" to connect to
the access point.
Cannot use the wireless connection. Once you have activated the wireless connection please wait 30 seconds
EN
Unplug unit from AC outlet for 20 seconds. Plug unit back in and press
the [ (OPEN/CLOSE)] on the unit to eject the disc.
The format of the USB memory stick is not compatible with this unit.
If the USB memory stick has been formatted on a PC or another device,
the file system may be incompatible with this unit. This unit supports the
FAT16 / FAT32 file systems.
Make sure that the disc was recorded in the UDF, ISO9660 or JOLIET
format.
Make sure that the file extension is .jpg / .JPG / .jpeg / .JPEG. / .png / or
.PNG.
Make sure that the disc was recorded in the UDF, ISO9660 or JOLIET format.
Confirm that the bitrate and sampling frequency are compatible with this unit.
(Refer to page 20)
Make sure that the file extension is MP3, AAC, FLAC or WAV for music files.
CDs/DVDs containing FLAC (.flac) files with high frequency and large
quantization bit rates may not play properly. In such cases, copy the
music files to a Blu-ray Disc™ or USB memory stick, then try playing.
Make sure the audio system is turned on.
Check the input mode on the audio system if it is on the correct channel.
Check if the surround system is compatible with either bitstream or
LPCM. If not sure please check the user manual or contact the surround
manufacturer. Once confirmed check the setting in the "Setup" on this
unit.
Increase the volume level on the surround system.
Make sure that the ethernet cable is properly connected to the modem /
router.
Confirm that another device, such as a PC, can connect to the Internet.
Check to see if the modem / router has power turned on.
Make sure that the ethernet cable is properly connected to the modem /
router.
Confirm if the Internet light is showing activity (light blinking) on the
modem / router.
Check network settings on the unit.
Turn off this unit and the modem/router (if it has a power button), then
unplug their AC cords. After 30 seconds, plug them back in and turn the
devices back on. If you have a telephone / Internet modem with your
cable service, then you may have to use its reset button or remove the
backup battery to reset this type of modem. Now wait for the lights to
show activity and try reconnecting.
Check the cable connection to the router when connecting with an
ethernet cable.
Confirm "Network Status" in the setup.
Turn on the DHCP function on the router.
If the access point's security mode is set to "WEP", change the setting to
"WPA" or "WPA2 (recommended)", then try "Auto" again. Refer to
Note
" D " on page 45. (For access point configuration, please consult
its user manual or manufacturer.)
Connect the unit to the access point using "Scan" or "Manual" mode.
for the connection to be established after turning on the unit, before
trying to access network features such as BD-Live™ and third-party
network services.
60
T ip
continued on next page