Philips 275V8 User Manual page 26

8.Troubleshooting & FAQs
• Adjust the image using the "Auto"
function in OSD Main Controls.
• Eliminate the vertical bars using the
Phase/Clock of Setup in OSD Main
Controls. It is valid only in VGA mode.
Image appears blurred, indistinct or too
dark
• Adjust the contrast and brightness on
On-Screen Display.
An "after-image", "burn-in" or "ghost
image" remains after the power has
been turned off.
• Uninterrupted display of still or
static images over an extended
period may cause "burn-in", also
known as "after-imaging" or "ghost
imaging", on your screen. "Burn-in",
"after-imaging", or "ghost imaging"
is a well-known phenomenon in
LCD panel technology. In most cases,
the "burn-in" or "after-imaging"
or "ghost imaging" will disappear
gradually over a period of time after
the power has been switched off.
• Always activate a moving screen
saver program when you leave your
monitor unattended.
• Always activate a periodic screen
refresh application if your LCD
monitor will display unchanging
static content.
• Failure to activate a screen saver, or
a periodic screen refresh application
may result in severe "burn-in" or
"after-imaging" or "ghost imaging"
symptoms that will not disappear
and cannot be repaired. The damage
mentioned above is not covered
under your warranty.
Image appears distorted. Text is fuzzy or
blurred.
• Set the PC's display resolution
to the same mode as monitor's
recommended screen native
resolution.
Green, red, blue, dark, and white dots
appears on the screen
• The remaining dots are normal
characteristic of the liquid crystal
used in today's technology, Please
refer the pixel policy for more detail.
* The "power on" light is too strong and
is disturbing
• You can adjust "power on" light
using the power LED Setup in OSD
main Controls.
For further assistance, refer to the Service
contact information listed in Important
information manual and contact Philips
customer service representative.
* Functionality different according to
display.
24