Pioneer FH-2037 ZF X1R/UC Service Manual page 62

1
- How to remove the CD Core Unit(S9MP3)
A
1. Give jumper-solder treatment to the Flexible Wire of
the Pickup unit, then remove the wire from the
Connector.
2. Remove all 4 points of solder-treatment on the Lead
Wire. Also, unscrew the screw(1 piece).
3. Then, Remove the CD Core Unit(S9MP3).
(Caution)
Be careful not to damage SW when you reassemble
the CD Core Unit(S9MP3) into the device.
B
- How to remove the Loading Arm Assy
1. Unlock the spring (1 piece) and remove the E ring (1
piece) of the Fulcrum Shaft.
C
2. Shift the arm to the left side direction and unlock pins
(2 pieces).
D
- How to remove the Pickup Unit
1. Unscrew 2 pieces of screws, then remove the Pulley
Cover.
2. Remove the Feed Screw unit from the pawl of the
E
Feed Screw Guide (The pawl is located inside the
guide).
3. Remove the belt from the Pulley, then remove the
Pickup unit.
(Caution)
Make sure not to stain the belt with grease when you
fix the belt.
F
62
1
2
CD Core Unit
(S9MP3)
Loading Arm Assy
Pulley Cover
FH-2037ZF/X1R/UC
2
3
Jumper-Solder
Grease Application Pickup Unit
Grease Application
3
4
Solder
Grease Application
Belt
Feed Screw Guide
4