Vinotemp Element EL-32COMM-B Owner's Manual page 12

Operating Your Wine Cooler
The wine cooler should be placed in a position where the ambient temperature is
between 5 -38°C/41-100°F. Humidity level is between 45~90%. If the position is
above or below this range, the performance of the unit may be affected. For example,
placing your unit in extreme cold or hot conditions may cause interior temperature to
fluctuate.
NOTE:
 When you use the wine cooler for the first time or restart the wine cooler after
having been shut off for a long time, there could be a few degrees variance
between the temperature you select and the one indicated on the LED readout.
This is normal, and it is due to the length of the activation time. Once the wine
cooler is running for a few hours, everything will be back to normal.
 If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes
before restarting the unit. If you attempt to restart before this time delay, the wine
cooler will not start.
The controls of your wine cooler
1
°F /°C Selector
1
Select the temperature display setting in Fahrenheit or Celsius degree.
Set temperature
2
Press this button,
display for 5 seconds
Backlight
3
4 Temperature Display
You can
view the SET and
The DISPLAY temperature
5
Up
6
Down
12
3
2
and the "SET" on SET temperature will temporarily "flash" in the LCD
Within 5 seconds, you can press
.
Used to turn on/off the backlight.
DISPLAY
shows you the current temperature of your wine cooler.
Used to raise (warm) the set temperature by 1°C or 1°F .
Used to lower (cool) the set temperature by 1°C or 1°F .
4
or
temperature in the
°C /°F Display
7
6
5
to set the temperature
at any time.