Kodak DC290 User Manual page 84

Problem
Computer cannot
communicate with the camera.
Picture is not clear in Burst
mode.
78
Camera Problems
Cause
Camera power is off.
The Mode dial is not
set to Connect.
Conflict with another
device.
Some Advanced
Power Management
utilities on laptops can
turn off ports to save
battery life.
Camera is not
connected to USB
cable or cable is not
connected to the
computer USB port.
Due to the higher
number of pictures
per burst with
Standard resolution,
pictures are
subsampled before
processing rather than
after processing.
There are less pixels
and slightly lower
sharpness.
Solution
Turn on the camera.
Set the Mode dial to
Connect.
Refer to the USB.PDF
or Connect.PDF
document supplied
with the camera
software, or your
computer User's Guide.
See the Power
Management section of
your laptop user's
guide to disable this
feature.
Connect USB cable to
camera and computer
USB port. See page 65.
Use a higher resolution,
which yields fewer
frames per burst.