Table of Contents
Advertisement
3. Replace the six rubber display bumpers around the display bezel.
Display Panel
CAUTION:
NOTICE:
NOTICE:
begin working inside the computer.
Removing the Display Panel
1. Follow the instructions in
2. Remove the display assembly (see
3. Remove the display bezel (see
4. Remove the eight M2 x 3-mm screws (four on each side of the display panel).
5. Lift the display panel out of the display back cover.
1 display panel
4 grounding wire and captive screw
6. Press in both sides of the top flex-cable connector, and pull the top flex-cable connector away from the display connector.
7. Pull straight up on the pull-tab to disconnect the bottom flex-cable connector from the inverter connector.
Great user manuals database on
Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
To help prevent damage to the system board, you must remove the main battery (see
Before You
Begin.
Removing the Display
Removing the Display
2 display back cover
UserManuals.info
Assembly).
Bezel).
3 M2 x 3-mm screws (8)
Before Working Inside Your
Computer) before you
Advertisement
Table of Contents
