Table of Contents
Advertisement
8. Display structure
By default, the UMU-FD 2 switches to monitoring mode for process monitoring. The
UMU-FD 2 can be switched to configuration or simulation mode using the buttons on
the front panel.
UMU-FD 2
Line 1 shows the scaled process va-
lue
Line 2 shows the selected enginee-
ring unit
Line 3 shows the analog output value
or TAG number
Line 4 shows the relay and communi-
cation status as well as the signal
history
8.1 Operation of the function keys
When using the FD 2 front display to configure a UMU device, you are guided
through all parameters and can select the appropriate settings for the respective ap-
plication. There is a scrolling help text for each menu, which is automatically shown
on the 3rd line of the display.
The configuration can be carried out using 3 function keys:
•
With ▲ you can increase the numerical value or select the next parameter.
•
With ▼ you can decrease the numerical value or select the previous parame-
ter.
•
With OK you can save the selected value and continue to the next menu.
After completing the configuration, the display returns to the normal state (monitor-
ing). If 3 is held down, one can return to the previous menu or to the normal state
without saving the changed values or parameters.
If no key is pressed for 1 minute, the display returns to the normal state without sav-
ing the changed values or parameters.
For more information on the device-specific programming menus, please refer to the
operating instructions for the respective device.
promesstec GmbH I Niedersachsenstraße 4 I D- 48465 Schüttorf I Tel.:+49 (0)5923/ 90 229 0 I Fax:+49 (0)5923/ 90 229 29
E-Mail: office@promesstec.com I Internet: www.promesstec.com
11
Advertisement
Table of Contents
