Advertisement
VANCE & HINES SYSTEM INSTALLATION
1. Install mounting bracket (1275-P) using supplied M10 bolts (A949HW). (Do not fully
tighten at this time).
2. Install exhaust using stock exhaust port nuts. (Do not fully tighten at this time).
3. Fasten exhaust to mounting bracket using the two supplied 1/4-20 screws (A304HW).
4. Tighten cylinder exhaust port nuts evenly.
5. Tighten muffler mounting screws.
6. Tighten mounting bracket bolts.
EXHAUST CARE (BLACK)
1. When installing a new set of black pipes, make sure your hands are clean and free
from oil. After installation, thoroughly clean pipes with warm soapy water and a soft
cloth. Dry with a clean towel to remove any residue before starting the motorcycle. Do
NOT use anything abrasive to clean pipes.
2. Avoid long periods of idling as this can cause discoloration.
3. Intake leaks can cause the engine to run lean and overheat, this could lead to
discoloration.
4. Make sure there are no exhaust leaks at the junction of the exhaust pipes and the
cylinder head. We recommend replacing gaskets if they are worn.
Page 3 of 4
H520IN
Advertisement
