Advertisement
HARDWARE
TOOLS REQUIRED
Allen Wrench: 4mm
STOCK SYSTEM REMOVAL
1. Remove the two cylinder exhaust port nuts from head pipe, located at the cylinder
head. (Save for reuse)
2. Remove the splashguard bolt, located on the rear fender.
3. Remove the two exhaust chassis mount bolts.
4. Remove the complete exhaust system and set aside.
5. Check the condition of exhaust gasket and replace if worn or damaged.
Page 2 of 4
2
3
Sockets: 10mm, 14mm, 15mm
Ratchets: 1/4", 3/8"
Extentions: 1/4"DR EXT Bar 6"
3/8 "DR EXT Bar 6"
4
H520IN
Advertisement
