Install The Sidewall Panels - Kohler 97631-G9 Installation And Care Manual

12. Install the Sidewall Panels

NOTE: Use silicone adhesive if the panels are being installed over tile. Use bath and shower construction
adhesive for all other applications.
Apply adhesive to the sidewall panel in a circular pattern. The beads of adhesive should be 5" (127
mm) to 7" (178 mm) apart.
Apply a bead of construction adhesive along the edges of the wall panel 3/4" (19 mm) from the
edge.
Move the wall panel into place at a slight angle, pressing the wall panel into the corner joint, if
installed.
Push the wall panel against the rough wall. Press firmly and evenly across the entire wall panel.
The wall panel should contact the rough wall along the entire area.
Remove the excess adhesive with your finger.
NOTE: Bracing may be needed to hold the wall panel in place depending on the rough wall material and
adhesive being used.
When installed over tile, use a temporary brace to secure each wall panel in place for 48 hours to
allow full adhesion.
Repeat these steps with the second side of the enclosure.
Kohler Co. 17 1248925-2-C