Advertisement
inwall style, 4 output) or IR55 (tabletop style, 4 output)
connection block, be used.
3. Wires can be solid or stranded, shielded or unshielded with a
minimum of 28-gauge for runs under 200', 22-gauge for runs
under 500' and 20-gauge for runs up to 1000'. Wires can be
looped from IR210 to IR210 or home run. Home runs generally
offer more reliability and future flexibility.
4. IR210s can be mixed and matched in larger systems with up
to 10 infrared receivers, such as the Knoll IR10 or IR22.
5. To wire the system together, connect the IR210 12V, GND
and SIG terminals to the corresponding IR54 or IR55 terminal.
Prepare the wire leads to and from the IR210 by stripping about
¼" of the insulation from each of the three leads. Twist the
strands tightly together so that they do not stick out of the
connector and cause a short circuit. Strictly observe polarity. If
you are connecting with the RJ45 connector you may need a
RJ45 paralleling strip to parallel connect the wires from multiple
IR receivers.
IR210
Inf rared
Receiv er
RJ4 5
IR55
12V
GND
SI G
IR210
Connection
Block
Inf rared
Rec eiv er
Note: IR210's are
RJ4 5
wired in parallel
PS1202
12 V DC Power Supply
Receiver
IR31A
CD
IR34A
171
Dish
IR34A
6. Next, plug the single or dual emitters into the IR54 or IR55
connection block.
7. Now, plug in the PS1202 (for up to five receivers) or PS1205
for five to ten receivers.
8. The infrared system is usually left plugged in all the time (to
an unswitched outlet) as it uses very little power.
9. Test the infrared system to see if it is working properly.
Bright sunlight and passive infrared security systems can lower
the distance that remote controls can work with an IR210
receiver. If you have any questions or concerns, please call and
ask for infrared technical support at 1 800 566 5579. The Help
Line is open from 7:30 a.m. to 5:00 p.m., Monday to Friday,
Pacific time.
RJ45
IR210
Infrared
Receiver
RJ45
Blue
talkback
LED
IR
Receiver
Advertisement
