Hansen Technologies HSC4H-N10K Specifications, Applications, Service Instructions & Parts page 22

Gas Detection Test Certificate Hansen Test Certificate
Product Description:_____________________
Date of First Calibration:__________________
Type/Range of Test Gas:_________________
1. Carry out "Bump Test" (Set delay to zero)
Power (Green LED)
Visual Alarm (Red LED)
Audible Alarm Operating
Relay Operating
Remote Systems if connected
to relay
Check Analog Output in Use,
e.g. 0-5V, 4-20 mA
2. On-Site Gas Calibration
System Passed
If the Gas Sensor did not respond correctly and could not be recalibrated due to age, exposure to gas etc,
then either the Gas Sensor or the sensing element should be replaced (and recalibrated.)
System Failed
I hereby certify that the above specified test procedure has been performed.
The Hansen Gas Sensor (is)/(is not) performing as specified
Test Performed by: ________________________________
A100g
JULY 2017
Serial Number:__________________________
Date of Last Calibration:___________________
Initial the following, encircle "OK" when completed.
_______________________________ OK
_______________________________ OK
_______________________________ OK
_______________________________ OK
_______________________________ OK
_______________________________ OK
Initial the following, encircle "OK" when completed.
_______________________________ OK
_______________________________
Signature
22
.
Encircle the appropriate conclusion.
_________________________
Date