Klipsch LightSpeaker 5.2.0 Owner's Manual page 16

B) Removal of the lens AFTER your LightSpeaker
has been installed.
1) There are three small indentations around the
lens; with a small tip common screwdriver, nail file,
paper clip or similar object, gently slip the tip into
the indentation and pry the lens outward until the
retaining tabs pull free.
2) To re-install the lens, align the tabs and the
hole for the pairing LED, then push gently until the
locking tabs snap into place.
CAUTION: Do not touch the LED or Speaker Baffle with
the lens off when the unit is hot, allow the unit to cool
down before touching the baffle.
16
Tech Support: 1-800-KLIPSCH
5
®