System Operation; Remote Control - Klipsch Klipschorn User Manual

RF Remote Control
Your radio-frequency (RF) remote control comes with its battery
installed. If you find the remote control is conflicting with another
nearby iFi system, see the "Remote Control" section for instruc-
tions on synching the dock with the remote control.

SYSTEM OPERATION

Power
The Main Power switch on the rear of the iFi subwoofer must be
On for the system to operate. You can switch the system between
Standby and On modes from the control dock or with the remote
control. The Power LED on the control dock will glow amber in
Standby mode and green when the system is On. No light indicates
that the Master Power switch on the subwoofer is turned Off or
that the power cord is unplugged.
Standby/Mute Button
In Standby mode, pushing the Standby/Mute button will switch
the iFi system On. If an iPod is in the dock, it will be turned On
as well.
When the system is On, pressing the Standby/Mute button will
mute the sound and pause the iPod. Pressing the button again will
unmute the system. Pressing and holding the Standby/Mute button
will switch the system to Standby. In Standby mode, the iPod will
continue to charge.
Volume/Subwoofer Select Button
The default function of the Volume knob is to adjust the overall
sound level up and down. It can also be used to adjust the sub-
woofer output level relative to the satellites.
To adjust the subwoofer level, first push the Volume/Subwoofer
Select button, then turn the Volume knob. The Light Bar will
now indicate the relative subwoofer level. Pressing the Volume/
Subwoofer Select button again will switch the knob back to master
volume control. NOTE: When in the Subwoofer mode, the system
will automatically revert to master volume after five seconds.
Light Bar
The light bar on the control dock indicates current master
volume or subwoofer level, depending on the setting of the
Volume/Subwoofer Select button. Volume is indicated by
consecutive LEDs, from left to right. Muting the system flashes the
volume LED's.
When subwoofer level is being adjusted, the light bar will
indicate the relative subwoofer level as shown below.

REMOTE CONTROL

The remote has five buttons to control basic player functions when
an iPod is in the dock. Because it uses radio-frequency (RF) rather
than infrared signaling, it does not have to be pointed at the iFi
dock. The remote control can operate the iFi system up to 100 feet
away, depending on conditions, and even works through walls and
floors! As long as the Master Power switch is in the On position
and the subwoofer is On, pressing the Play/Pause button on the
remote will switch the system from Standby to On.