Subscribe to Our Youtube Channel
Related Manuals for MS Sedco INTERSECTOR SDLC
Summary of Contents for MS Sedco INTERSECTOR SDLC
- Page 1 USER’S GUIDE INTERSECTOR SDLC ™ MICROWAVE VEHICLE MOTION SENSOR FOR USE WITH THE MS SEDCO INTERSECTOR HUB V0221-01-TC-0A-SDLC...
- Page 2 • No privacy concerns • Reduces construction cost Through the INTERSECTOR HUB portal, the INTERSECTOR SDLC allows users to visually track vehicles as they approach the intersection and allows easy setup of detection zones to provide programmable inputs to a traffic control cabinet.
- Page 3 MOUNTING LOCATION – GUIDELINES IMPORTANT NOTE: MS Sedco recommends a “Pre-Analysis” be performed for the intersection where the INTERSECTOR SDLC is to be installed. The Pre-Analysis provides key information that can be helpful with the initial setup of the sensor relative to mounting height, distance from detection zone, number of lanes, etc.
- Page 4 ELECTRICAL INSTALLATION 1. All power and data for the INTERSECTOR SDLC is accomplished through any of the 6 sensor ports provided at the INTERSECTOR HUB. An ethernet cable with RJ45 connections must be plugged in at the back of the INTERSECTOR SDLC and at one of 6 sensor ports.
- Page 5 Clip is on opposite side RJ45 Jack EIA/TIA 568B Std. CONFIGURATION AND PROGRAMMING Upon successful mechanical installation of the INTERSECTOR SDLC and cabling to the HUB, refer to the INTERSECTOR HUB User’s Guide for complete programming and setup instructions. TESTING & VALIDATION Upon completion of all Intersector and HUB installation and setup procedures, all functions shall be tested to ensure safe and reliable performance.
- Page 6 If, during this period, the product fails to operate and has not been tampered with or abused, the unit can be returned prepaid to the factory and be repaired free of charge or replaced, as determined by MS Sedco. After five years, the unit may be repaired for a nominal service charge.
- Page 7 “Measure distance”. Follow instructions on Google Maps to select measurement points. The result will be displayed on the measurement line and also in a dialogue box at the bottom of the map. MS SEDCO V0221-01-TC-0A-SDLC Page 7...
Need help?
Do you have a question about the INTERSECTOR SDLC and is the answer not in the manual?
Questions and answers