Replacing Bearings; T-Ring Roller - DALBO DINCO CLASSIC 300 Manual

Replacing bearings

When DINCO CLASSIC is lowered the rear roller is supported so that the arms (A) rests
on the lower pin (B).
1. Remove the bolts in each side of the flange bearings (C).
2. The cage roller/t-ring roller can be rolled away.
3. Loosen the pointed screws in each bearing and the bearing can be removed from
4. Mount new bearings loosely on the shaft. Roll the cage roller/t-ring roller back in
5. Secure the pointed screws with Locktite and tighten well.
Fig. 12

T-ring roller

The t-ring roller has been designed with a centre bearing to support the shaft.
1. Remove the centre bearing in the middle together with the flange bearings.
2. When the bearings are free, lift DINCO CLASSIC. The t-rings and shaft are now free.
3. Loosen the pointed screws and remove the flange bearings.
4. Remove the t-rings in one side of the center bearings to change the bearing.
5. Having changed the center bearing mount the rings. Mount in reverse order.
Removing rings from the shaft can be quite hard. Try cleaning the area between the
rings and the shaft with a high pressure cleaner to remove dirt and corrosion that
may be present.
Fig. 13
Page 18
the shaft.
between the bearing plates. Bolt the bearings onto the these.
B
Secure the pointed screws with Locktite.
A
A
C