Advertisement
Advanced Features
Deep scratch cycle
In the starter pack you will find a blue pad. This is
the deep scratch 'heavy' pad. This is if you have a
disc that you feel needs a longer repair than the
standard '4' cycle will repair.
The machine can only hold four pads at a time and
so to run the fifth, heavy cycle you need to exchange
the blue pad with the red pad for the 5th stage.
Please follow the sequence below for using the
'5, heavy' cycle:
1. Remove the red pad holder from the machine and
remove the red pad from the holder.
2. Attach the blue pad on to the red pad holder and
replace the pad holder on to the machine.
3. Place the heavy damaged disc on to the platen as
normal, close the lid and press '5'.
4. The display will count down the '5' cycle.
5. When it moves on to cycle 4 press any button. This
will pause the repair and open the drawer.
6. Now exchange the blue pad with the red pad, close
the door and press '4'.
7. The machine will now finish stages 4 to 1 as normal.
©Total Disc Repair Ltd | www.totaldiscrepair.co.uk | Technical Support: 0800 412 5424 - support@totaldiscrepair.co.uk | Sales: 01202 489 500 - sales@totaldiscrepair.co.uk
Using the Blu-ray cycle
Your Eco Clever disc repair machine has already
been installed with the Blu-ray software required to
repair Blu-ray discs. See the 'Disc Types' data sheet
for more information on the differences with Blu-ray
discs.
Follow the procedure below to change your machine
to Blu-ray repairs:
1. Open the front door.
2. Remove yellow pad and holder from the turret.
3. Fit violet pad and holder in its place.
4. With the door open, press and hold MODE/STOP
button until
changes to
5. Place disc on turntable, close door and select a
cycle based on level of damage - there is no level 5
in Blu-ray repair mode.
6. When you've finished, press and hold MODE/STOP
again to return to
mode and replace the yellow
pad.
Your notes...
Advertisement
