Advertisement
Getting Started
Initial setup
With the machine you will find an initial set up guide
which includes a list of contents and also explains the
setup of the machine.
Basic operation
Choose a disc for repair. For this first disc we will run
a light (average) repair cycle.
1. Press 'mode/stop' to open the front door.
2. Place the disc shiny side up on the turntable.
3. Gently close the door.
4. Press the '3' button (light repair).
AL 12 - if this shows on the display please check that
the pad holders are positioned correctly. For any other
alarm codes or issues please consult the Maintenance
and Information sheet or contact Technical Support.
Inspecting a repaired disc
The disc should come out of the machine clean and
dry. Have a look at the repaired side, the light repair
should have made a visible improvement.
If a more heavily damaged disc was chosen the disc
may need an additional repair. Now, using the cycles
1-4, try different levels of damage to get a better
understanding of what the machine can do.
For Blu-ray and heavily damaged discs (Level 5)
please refer to the Advanced Features section.
©Total Disc Repair Ltd | www.totaldiscrepair.co.uk | Technical Support: 0800 412 5424 - support@totaldiscrepair.co.uk | Sales: 01202 489 500 - sales@totaldiscrepair.co.uk
Parts of the machine
Place shiny
side up
on the
turntable
Disc turntable
This is where the disc is
positioned for the repair. It
sits with shiny side facing up.
Front
Waste exit
Please ensure the tube is connected
during operation.
Operation panel
Front door latch
Pad turret
Positioning of the
pad holders and
polishing pads.
Polish/
Water entry
and splash
back tray
Fan
Feed tubes
Compound
pump
Stage
Display
MODE/
STOP
button
The LCD indicates:
Repair cycle options
Time remaining
Warnings
Back
Power
switch,
fuse and
AC inlet
Water
pump
Advertisement
