Advertisement
Getting To Know The Machine
Understanding the repair cycle
The Eco Clever is a multi stage disc repair machine.
In other words, during the repair cycle the machine
uses different grade pads in stages to repair the disc.
Sound complicated? Don't worry the Eco Clever does
all of these stages automatically.
Inside the machine there are four colour coded
abrasive pads from coarse to fine.
Button
Repair Mode
4
Medium
Raised scratches
3
Light
Narrow scratches
2
Very Light
1
Clean/Polish
Dirt/fingerprints
Refer to Advanced operation for deep gouges. (level 5)
Clean/Polish
Very Light
Light
Medium
The machine automatically engages each pad in
sequence. The coarsest pad will remove the most of
the scratch whereas the finest pad produces the high
quality finish.
©Total Disc Repair Ltd | www.totaldiscrepair.co.uk | Technical Support: 0800 412 5424 - support@totaldiscrepair.co.uk | Sales: 01202 489 500 - sales@totaldiscrepair.co.uk
Setting up consumables
The basic setup for the machine uses pads with red,
green, yellow, and black coloured velcro and these
will have been pre-installed.
Each pad is attached using Velcro to a matching
coloured pad holder. The pad holder is then held in
the machine by a magnet.
Try removing and replacing the pad holders.
Description
On the turret there is a coloured label showing where
the corresponding coloured pad should go.
Match each coloured pad holder to the
Light scuffs
corresponding colour tab:
You will have also received blue and violet pads and a
violet pad holder with the machine. Please put these
aside as they will be used in Advanced Features
later.
Replacing the pads
When a pad needs changing the machine displays an
alarm code. These codes are:
ST LED
Al
Press any button to cancel the alarm. Then change
the relevant pad. Once the pad has been changed
you need to reset the counter on the machine.
Pad changing sequence:
Yellow tab
indicates
yellow
pad holder
location
1. Lift off pad holder
See
Advanced
Features
for violet
pad use
3. Attach new pad
With the door open, press the corresponding cycle
button to display the counter reading.
To reset the counter press the button again and hold
it down until the counter changes to zero.
Time LED
Description
01
Exchange Pad #1
02
Exchange Pad #2
03
Exchange Pad #3
04
Exchange Pad #4
05
Change Compound
2. Remove used pad
4. Re-attach pad holder
Advertisement
