Applications; Svp-Ex; General Description; Tl431 - Hitachi 32LD8700C Service Manual

11.3.3.

Applications

Circuits for safe protective separation against electrical shock according to safety class II (reinforced
isolation):
For appl. class I – IV at mains voltage 300 V
For appl. class I – III at mains voltage 600 V
According to VDE 0884, table 2, suitable for: Switch-mode power supplies, line receiver, computer
peripheral interface, microprocessor system interface.
11.4.

SVP-EX 52

11.4.1.

General Description

SVP EX52 supports two CVBS and one Svideo,two HD YPbPr component or PC RGB input and one
24-bit digital input ports.Supports HD YPbPr de-interlacing mode and 3D-comb video mode.
LVDS "single" port is built-in, supporting output resolution up to SXGA, 1280x1024x60P.
11.5.

TL431

11.5.1. General Description
The TL431/TL431Aare three-terminal adjustable regulator series with a guaranteed thermal stability
over applicable temperature ranges. The output voltage may be set to any value between Vref
(approximately 2.5 volts) and 36 volts with two external resistors These devices have a typical dynamic
output impedance of 0.2W Active output circuitry provides a very sharp turn-on characteristic, making
these devices excel lent replacement for zener diodes in many applications.
11.5.2.

Features

Programmable Output Voltage to 36 Volts
Low Dynamic Output Impedance 0.20 Typical
Sink Current Capability of 1.0 to 100mA
Equivalent Full-Range Temperature Coefficient of
50ppm/°C Typical
Temperature Compensated For Operation Over Full Rated
Operating Temperature Range
Low Output Noise Voltage
Fast Turn-on Response
11.6.

24C32

11.6.1. General Description
The Microchip Technology Inc. 24C32 is a 4K x 8 (32K bit) Serial Electrically Erasable PROM. This
device has been developed for advanced, low power applications such as personal communications or
data acquisition. The 24C32 features an input cache for fast write loads with a capacity of eight 8-byte
pages, or 64 bytes. It also features a fixed 4K-bit block of ultra-high endurance memory for data that
changes frequently. The 24C32 is capable of both random and sequential reads up to the 32K
boundary. Functional address lines allow up to 8 - 24C32 devices on the same bus, for up to 256K bits
address space. Advanced CMOS technology makes this device ideal for low-power non-volatile code
and data applications.
11.6.2. Features
• Voltage operating range: 4.5V to 5.5V
- Peak write current 3 mA at 5.5V
- Maximum read current 150μA at 5.5V
- Standby current 1μA typical
• Industry standard two-wire bus protocol, I
-Including 100 kHz and 400 kHz modes
• Self-timed write cycle (including auto-erase)
• Power on/off data protection circuitry
• Endurance:
TFT TV Service Manual
2
C™ compatible
8