Using - Panasonic ER-GN300 Operating Instructions Manual

Using

1. Remove the protective cap and hold
2. Slide the power switch on the main body
3. Trim
Trimming your nose hair and ear hair
1. Insert the tip ( ) of the outer blade into your nostril or ear
2. Cut the nose hair and ear hair by moving the main body.
Outlining your eyebrows, moustache, or beard
1. Apply the tip of the outer blade to the hair (eyebrow,
2. Cut the hair by moving the appliance slowly against the
4. After use, slide the power switch on the main body to the
10
PB016214 - ER-GN300
the main body so as not to block the
exhaust hole ( ).
to the "O" position to turn on the power.
• The outer blade surface may get a little
warm during use, but performance will
not be affected.
canal.
• Insert it slowly so as not to injure your nostril or ear canal.
• Cut hairs using the tip ( ) of the outer blade (metallic part).
• Some trimmings may remain inside your nostril or ear canal
after cutting, so remove them using a tissue or similar.
moustache or beard) you would like to cut.
direction of hair growth.
• You cannot trim the hair to length with this appliance.
• It is not suitable for the hair below 0.5 mm.
"I" position to turn off the power and clean it.
(See page 11).
_(01GB)_06-20-18.indd 10 2018/6/20 10:53:51