Dell EMC PowerEdge R7515 Reference Manual page 12

NOTE: Network Settings are not supported in BIOS boot mode.
Table 12. Network Settings details
Option
UEFI PXE Settings
PXE Device n (n = 1 to 4)
PXE Device n Settings(n = 1 to 4)
UEFI HTTP Settings
HTTP Device n (n = 1 to 4)
HTTP Device n Settings (n = 1 to 4)
UEFI iSCSI Settings
Table 13. PXE Device n Settings details
Option
Interface
Protocol
Vlan
Vlan ID
Vlan Priority
Table 14. HTTP Device n Settings details
Option
Interface
Protocol
Vlan
Vlan ID
Vlan Priority
DHCP
IP Address
Subnet Mask
Gateway
DNS info via DHCP
Primary DNS
Secondary DNS
URI
12 Pre-operating system management applications
Description
Enables you to control the configuration of the UEFI PXE device.
Enables or disables the device. When enabled, a UEFI PXE boot option is
created for the device.
Enables you to control the configuration of the PXE device.
Enables you to control the configuration of the UEFI HTTP device.
Enables or disables the device. When enabled, a UEFI HTTP boot option is
created for the device.
Enables you to control the configuration of the HTTP device.
Enables you to control the configuration of the iSCSI device.
Description
Specifies NIC interface used for the PXE device.
Specifies Protocol used for PXE device. This option is set to IPv4 or IPv6. This option is set to
IPv4 by default.
Enables Vlan for PXE device. This option is set to Enable or Disable. This option is set to
Disable by default.
Shows the Vlan ID for the PXE device
Shows the Vlan Priority for the PXE device.
Description
Specifies NIC interface used for the HTTP device.
Specifies Protocol used for HTTP device. This option is set to IPv4 or IPv6. This option is set
to IPv4 by default.
Enables Vlan for HTTP device. This option is set to Enable or Disable. This option is set to
Disable by default.
Shows the Vlan ID for the HTTP device
Shows the Vlan Priority for the HTTP device.
Enables or disables DHCP for this HTTP device. This option is set to Enable by default.
Specifies IP address for the HTTP device.
Specifies subnet mask for the HTTP device.
Specifies gateway for the HTTP device.
Enables or disables DNS Information from DHCP. This option is set to Enable by default.
Specifies the primary DNS server IP address for the HTTP Device.
Specifies the secondary DNS server IP address for the HTTP Device.
Obtain URI from the DHCP server if not specified