Software Bisque Paramount MX User Manual page 83

Axis Parameters
User Space Version
Focus Axis
Mount Identifier
Debug Output?
Startup Test Joystick RA
Startup Test Joystick Dec
Startup Test Joystick
Button
Startup Test Guider
Play Guider Sound
IR Enabled
Hand controller rate 1
Hand controller rate 2
Hand controller rate 3
Hand controller rate 4
General Purpose I/O 1
Description
Shows the current version for the format of the user-defined data that is
saved to the control system's flash memory.
MKS 3200. MKS 4000, MKS 5000 and later should be set to 1. Otherwise,
set this value to 0.
One of the following:
•
Paramount ME
•
Paramount MX
•
Bisque TCS
Set this value to 1 to show control system diagnostics.
If set to 1, then Bisque TCS will abort startup and emit a single beep if the
joystick is not centered when power is turned on.
If set to 1, then Bisque TCS will abort startup and the control system's
speaker will emit a single beep if the joystick is not centered when power
is turned on.
If set to 1, then Bisque TCS will abort startup and the control system's
speaker will emit a single beep if the joystick button is pressed when
power is turned on.
If set to 1, then Bisque TCS will abort startup and the control system's
speaker will emit a single beep if any of the guider lines are high when
power is turned on.
If set to 1, the Bisque TCS speaker will emit a single "click" each time the
guider state changes.
If set to 1, then the infrared communications port is enabled (MKS 4000
only).
Hand controller rate number 1.
Hand controller rate number 2.
Hand controller rate number 3.
Hand controller rate number 4.
General purpose output direction 1.
Paramount MX User Guide
83 | P a g e