Other Paramount Mx Accessories; Mini Usb Cable; Hex Wrenches; Power Supply Unit (Psu) - Software Bisque Paramount MX User Manual

Fully counterclockwise
* The slew rate for this position cannot be changed.
The rates for slew rate switch positions 1-4 can be configured when the hand controller is plugged into
the MKS 5000 control system. See "Hand Controller Settings" on page 110 for information how to do so.
The hand controller is compatible with the Paramount ME (specifically, MKS 4000 control
systems using firmware version 2.8.6 or later). However, the hand controller's slew rates
are not configurable when used in conjunction with the MKS 4000. In other words, the
default slew rates are configurable only via the MKS 5000 control system.

Other Paramount MX Accessories

Mini USB Cable

This cable connects the Paramount MX mini USB port to a USB port on the computer.

Hex Wrenches

The Paramount MX comes with a set of standard Imperial-size hex wrenches that can be used to tighten
the Versa-Plate knobs (page 41), add or remove the polar alignment scope (page 50), loosen the base
(page 52) or altitude adjuster thrust knobs (60) and other common setup tasks.

Power Supply Unit (PSU)

The Paramount MX power supply is compatible with either +120 or +240V power sources and comes
with a NEMA 5-style three pronged connector. Country-specific power plugs are available at most local
hardware or electronics shops.
•
Maximum power output: 80W
•
Input: 100-240VAC ~47-63 Hz 1.9A
•
Output: 48V 1.66A maximum
Switch Position
1
2
3
4
Paramount MX User Guide
Default Slew Rate (x Sidereal)
0x*
0.33x
3x
600x
1200x
63 | P a g e