Function Control; General; Safety Procedures - probst VTK-V Operating Instructions Manual

Safety
3.7

Function Control

3.7.1

General

•
Before every usage of the device check the functions and the working condition.
•
Maintenance and lubrication are only permitted when device is shut down!
•
Do not use the device, until all faults which can cause safety hazards are removed.
•
If there are any cracks, splits or damaged parts on any parts of the device, immediately stop using it.
•
The operating instructions must be available at the workplace every time.
•
Do not remove the type plate of the machine.
•
Unrecognisable information signs (such as regulatory or prohibition signs) must be replaced.
3.8

Safety procedures

3.8.1 General
•
The manual guiding of the device is only allowed at the handles.
•
The operator is not allowed to leave the control unit as long as the device loaded with load. The load
must always be in the range of vision of the operator.
•
While using the device the stay of persons in the working area is forbidden. Except it is indispensable,
caused of the way of using the device, e.g. if the device must be leaded by hand.
•
The jerky lifting and lowering of the device with and without load, e.g. caused through driving fast with
the lifting equipment/carrier over uneven grounds is forbidden. Unchecked movements of the device
can be the result. The gripping good could fall down.
•
The device should not be opened if the opening path of the gripping arm is blocked by a resistance.
•
Never exceed the carrying capacity/working load limit (WLL) and the nominal width of the device.
51100015 8 / 17 GB