Advertisement
FLUSH MOUNT RESTROOM INSTALLATION
1. Prepare the cut-out for the unit and fit in the dry wall bracket.
2. Slide in the black vinyl behind the flush aura enclosure and fit
them inside the dry wall bracket.
Note: Black vinyl does not come with the CM-45/4 - 4 1/2"
'Push To Open'.
3. Ensure the two mounting holes on the bracket and the Flush
aura enclosure align. Use the 8-32 phillips screws to completely
tighten in place.
4. Place the aura board inside the flush aura enclosure, making
sure the screw holes on the aura board align with the screw
holes inside the Flush aura enclosure. Use the #6 x 3/8"
self-tapping screws to tighten Aura board in place.
5. Place the Aura insert inside the Flush aura enclosure, making
sure the mounting screw holes on the aura insert and the flush
aura enclosure align.
Aura Insert
6-32 Phillips
screw (2 pcs)
Flush Aura
Enclosure
8-32 x 1-1/2"
Phillips Screw
(2 pcs)
Aura Board
#6 x 3/8" Phillips
self-tapping screw
(2 pcs)
Plastic spacer
(For use only on CM-2520/48)
WC13PS SERIES RESTROOM CONTROL
FOR CM-45/455SE1, CM-45/855SE1 & CM-45/4 SWITCHES
a. Use the 6-32 hex head screws to tighten the aura
insert slightly.
b. Fit in the assembled Push plate by locating the screws
with the holes on the backplate.
c. Fit the hex key through the hole on the face plate and
completely tighten the 6-32 screws in place.
FOR CM-2520-4855SE1 COMBO SWITCH
a. Fit the plastic spacer inside the aura insert
b. Place the combo switch Inside the aura insert, making sure
the mounting holes on the aura and on the back plate align.
c. Use the 6-32 Phillips screws to tighten in place
7. Apply the label to the black vinyl as required.
Black Vinyl
Dry Wall Bracket
Label
Aura Dip Switch Settings
Enable
REM/LOC
1
RELAY
2
SPEAKER
3
IN S TALL AT ION INSTRUCTIO NS
= Switch Position
Idle Color
Active Color
RED
1
1
GREEN
2
2
BLUE
3
3
RED
GREEN
BLUE
Page 4 of 11
Advertisement
