Advertisement
WC13PS SERIES RESTROOM CONTROL
I NSTA LLAT I O N I N S T RU C T I O N S
SURFACE MOUNT RESTROOM INSTALLATION
1. Place the white vinyl sign behind the surface aura enclosure
and place them against the mounting wall.
2. Use the #10 x 1'' pan head screws with the green pvc anchors
provided to hold the white vinyl sign and the aura enclosure
against the wall .
Note: White vinyl sign does not come with the
CM- 45/4 - 4 1/2" 'Push To Open'.
3. Place all the square rubber pads inside the flush aura enclosure.
Insert the aura board inside the flush aura enclosure, making
sure the screw holes on the aura board align with the screw
holes inside the surface aura enclosure. Use the #6 x 3/8"
self-tapping screws to tighten Aura board in place.
4. Place the Aura insert inside the surface aura enclosure, making
sure the mounting screw holes on the aura insert and the
surface aura enclosure align.
Aura Insert
6-32 Phillips
screw (2 pcs)
Page 3 of 11
#10 x 1"
Pan Head Screw
(4 pcs)
Aura Board
#6 x 3/8" Phillips
self-tapping screw
(2 pcs)
Plastic spacer
(For use only on CM-2520/48)
FOR CM-45/454SE1, CM-45/854SE1 & CM-45/4 SWITCHES
a. Use the 6-32 hex head screws to tighten the aura
insert slightly.
b. Fit in the assembled CM-45/4 by locating the screws
with the holes on the backplate.
c. Fit the hex key through the hole on the face plate and
completely tighten the 6-32 screws in place.
FOR CM-2520-4854SE1 COMBO SWITCH
a. Fit the plastic spacer inside the aura insert
b. Place the combo switch Inside the aura insert, making sure
the mounting holes on the aura and on the back plate align
c. Use the 6-32 Phillips screws to tighten in place.
5. Apply the label to the black vinyl as required.
White Vinyl
Label
Surface Aura
Enclosure
5/8" x 5/8" Square Rubber Pad (4 pcs)
Aura Dip Switch Settings
Enable
1
2
3
Active Color
RED
REM/LOC
1
RELAY
GREEN
2
SPEAKER
BLUE
3
= Switch Position
Idle Color
1
RED
2
GREEN
3
BLUE
Advertisement
