Sim Card Detection Test - Allied Telesis AlliedWare Plus AR Series Technical Manual

SIM card detection test

The following procedure is used to test SIM cards in both SIM 1 and SIM 2 card slots.
Step 1:
Step 2:
Step 3:
awplus#
awplus(config)#
awplus(config)#
awplus(config)#
awplus(apn-config)#
awplus(apn-config)#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
awplus(config-if)#
awplus(config)#
Step 4:
Use the show interface command. Observe that the 'wwan0' interface administrative state is up:
awplus#show int wwan0
Interface wwan0
Link is DOWN, administrative state is UP
Hardware is WWAN
index 14 metric 0 mtu 1428
<BROADCAST,NOARP,MULTICAST>
VRF Binding: Not bound
SNMP link-status traps: Disabled
Router Advertisement is disabled
Router Advertisement default routes are accepted
Router Advertisement prefix info is accepted
input packets 0, bytes 0, dropped 0, multicast packets 0
output packets 0, bytes 0, multicast packets 0, broadcast packets 0
input average rate : 30 seconds 0 bps, 5 minutes 0 bps
output average rate: 30 seconds 0 bps, 5 minutes 0 bps
Time since last state change: 0 days 00:04:13
C613-22132-00 REV A
Boot your router with no configuration and no SIM cards inserted
Check that both SIM 1 and SIM 2 LEDs are off
Configure your router
configure terminal
sim enable sim1
sim enable sim2
apn carrier1
name carrier_name.co.nz
exit
interface wwan0
apn sim1 carrier1
apn sim2 carrier1
exit
Display interface 'wwan0' information
5G Mobile Broadband UTM Firewall
|
SIM card detection test Page 39