Upgrading Firmware And Pri Files - Allied Telesis AlliedWare Plus AR Series Technical Manual

5g mobile broadband utm firewall
Table of Contents

Advertisement

Deleting firmware files
Use the command platform 5g delete to delete a firmware version file. The firmware file must not be
active. For example, if you try to delete firmware that is active the following message is displayed:
awplus#platform 5g delete firmware 2
%Firmware slot 2 version 03.04.03.00_x is active
For example, to delete the firmware version file from slot 1 which is not active:
awplus#platform 5g delete firmware 1
Successful operation

Upgrading firmware and PRI files

At times, you may need to update the PRI files and firmware files for your 5G modem, to provide
new features and fix bugs.
Note:
If you need to upgrade your firmware, follow this procedure:
Step 1:
Before upgrading the firmware, capture a copy of what is currently present on your EM9191 modem.
Use the command show 5g tech firmware.
Step 2:
Disable all installed SIMs before changing the firmware. The 'wwan0' port should be down. For
example, use the command no sim enable sim1 and no sim enable sim2.
Step 3:
Get the new files from Allied Telesis at this email: 5g-support@alliedtelesis.co.nz.
Step 4:
Copy the files into the desired directory. See the
Overview Guide
other files in the directory. The firmware upgrade may fail if you leave older versions of PRi files and
other files in the upgrade directory.
You can only have one firmware file in the directory. The firmware file is a large file, greater than 80
Megabytes. Its suffix ends in '*.cwe'.
You can have multiple PRI files. These files have the suffix '*.nvu' and need to be in the same
directory as the firmware file. These PRI files tend to be smaller, usually less than 10 Megabytes.
If you need to delete unwanted files from your modem, use the platform 5g delete command. You
cannot use the command platform 5g delete to remove files from usb or flash directories.
C613-22132-00 REV A
Firmware versions 1 and 2 support only one firmware slot. Version 3 supports 3 slots.
Capture your current settings
Disable the SIMs
Get the new firmware and/or PRI files
Copy the new files onto the device
for detailed information about copying files onto your device. There must be no
5G Mobile Broadband UTM Firewall
Configuration and File Management Feature
|
Carrier support
Page 21

Advertisement

Table of Contents
loading

This manual is also suitable for:

Alliedware plus at-ar4050s-5g

Table of Contents