Control Panel Diagnostic And Status Information - NETGEAR ReadyNAS 4200 Hardware Manual

Control Panel Diagnostic and Status Information

The control panel for the ReadyNAS 4200 is located on the bottom left corner of the unit.
Each function on the control panel is described in the table below.
Control panel
Item
Power
button
System
Reset
Power LED
Disk LED
16 | Chapter 2: Diagnostics and Maintenance
Activity Description
Push button Push to turn on the ReadyNAS 4200.The power LED blinks
while the ReadyNAS 4200 is booting.
Preferred shutdown: If the unit is running, pressing the power
button once will begin the graceful shutdown blink pattern on
the LEDs. Pressing the power button a second time within 5
seconds confirms and initiates the graceful shutdown.
Forced shutdown: If the unit is hung, you can press and hold
the power button for 5 seconds to force shutdown.
Push button Reset: Use a stick pin or paper clip to press the reset button
once to do a warm boot of the ReadyNAS 4200.
Diagnostics: To enter the diagnostic boot menu, see
"Understanding the System Diagnostics Boot Menu"
page 19.
On (Green) Green: The unit is powered on.
Off Off: The unit is powered off.
Blinking amber: Disk activity.
On/Blink
(Amber)
ReadyNAS 4200 Hardware Manual
Disk present and activity light
Disk failure light
on