Elcon ELCONnect next BIG 101 Series User Manual page 51

BIG 101x
Figure 21: Selection of the respective device firmware (continued)
After clicking on the „Apply" button (see figure 21) you will be prompted to acknowledge
your settings (see figure 22).
Please acknowledge the request by clicking on OK. This action will be followed by a warning
message (see figure 23).
Figure 23: Warning of non-accessibility during upgrade procedure
Acknowledgement by clicking on „OK" (figure 23) starts the upgrade process. If the option
„Reset to default settings after firmware upgrade" has been enabled, the user parameters will
be deleted and the device performs a restart with the default configuration (factory settings).
Version: 2010/12/01
Figure 22: Acknowledgement of the upgrade process
51