Elcon ELCONnect next BIG 101 Series User Manual page 42

BIG 101x
The submenu „System Time" allows the user to enable time synchronization of the
BIG 101x with an NTP-Server (Network Time Protocol) in the operator´s network and to set
the server that shall be used. To activate the automatical sychronization, put a tick in the
checkbox „NTP enable" and enter the IP-address/ name of the NTP-server under „NTP Serv-
er". Also, you may select the time zone in line with the installation place of your BIG 101x.
Figure 9: Setting of the system time
The submenu „Change password" allows you to set the user name and the password, as
well as the maximum time until the automatical logout in case of inactivity. With a click upon
the „Apply" button and subsequent click on „Save settings" the new login data will be perma-
nently stored and applied in the device.
Figure 10: Setting of login data for access to the BIG 101x
42 Version: 2010/12/01