Adjustment - benza CR 450 Use And Maintenance Manual

9. ADJUSTMENT

Do not use blade discs with a diameter in excess of 450 mm and with an inner diameter other than 25.4 mm.
Do not use blade discs other than those specified for this machine:
- Diamond blade disc for floor cutting.
In the event of detecting any fault in an element of the machine, take it out of service and contact your dealer
or the manufacturer.
Cutting depth:
Handle height:
- Turning the wheel right or left, we will raise or
lower the disc to adjust cutting depth.
- Start cutting slowly and uniformly.
- The handlebar of the machine may be fixed
at several heights.
- Loosen the lateral screws. (Part 1)
- Place the bar at the desired height.
- And tighten side screws back.
14