Charging; Charge The Ws1 Before Using It - WHEELSPEED WS1 User Manual

Section 4

CHARGING

4.1 Charge the WS1 before using it.

When the scooter is charging, the charger LED indicator is red. When the charger LED
indicator is turn green, the charge cycle is complete. Each charge cycle from zero to full
charge will take approximately 6 hours. When display on the handlebars indicates that
battery power is low, recharge the WS1. To recharge the WS1, use the included charger.
Step 1. Make sure the scooter is powered off then locate the charging port under the deck.
Step 2. Insert the appropriate end into the charging port and then insert the other end into an outlet.
Step 3. While the scooter is charging, the charger light will turn red.
Step 4. When the scooter is fully recharged, the charger light will turn green. You may then
disconnect the scooter from the charger.
DO NOT, under any circumstances, use the scooter while it is charging or connected to the charger.
And make sure to charge your scooter in conditions that do not exceed 104 F(40℃) or below 32 °F(0℃).
The charging time is approximately 6 hours. Charging longer than that may affect battery life and/or
performance. If the charger's light doesn't turn on, it may not be fully connected. Check that it is securely
connected to the wall and to the scooter.
Charging port
WS1 USER MANUAL 12