WHEELSPEED WS1 User Manual page 15

Step 2. Visually inspect the tire for damage, scuff, or puncture marks. If the tire is damaged,
DO NOT INFLATE IT. Contact customer service immediately.
Step 3. Find the valve located on the inside of the wheel and remove the cap, and connect the
tire pump extender to the valve.
Step 4. Use a standard bicycle pump to connect the pump extender to pump air slowly.
Step 5. Use the pressure gauge periodically to check PSI.
Step 6. When the tire reaches 210KPA/30PSI/2.1BAR, stop inflating and cover the valve cap.
• Any PSI marking on the tire indicates a maximum. DO NOT inflate the tire to this value,
only inflate it to 30PSI as directed above.
• Underinflation is strongly recommended if you intend to ride outdoors in temperatures
above 90°F degrees(32℃). Bring the WS1 indoors and deflate the front tire to 27 PSI. If the
PSI is too high and the tire are exposed to excessively high temperatures, riding outdoors
may cause serious damage to the tire including but not limited to stretching and/or rupturing.
11