Download Print this page

Sundstrom SR900 Manual

Modular respirator
Hide thumbs Also See for SR900:

Advertisement

Quick Links

SR900 — How to
Copyright © 2016 by The S.E.A. Group
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the SR900 and is the answer not in the manual?

Questions and answers

Summary of Contents for Sundstrom SR900

  • Page 1 SR900 — How to Copyright © 2016 by The S.E.A. Group...
  • Page 2 IMPORTANT: Never pull the head harness over a hard hat, ear muffs, goggles, cap or other head gear – the harness must be fitted DIRECTLY on your head. SR900 — How to Copyright © 2016 by The S.E.A. Group...
  • Page 3 Ensure that the flange of the filter fits into the groove all the way around the rubber fitting. Fit a pre-filter to the front of the main filter or combined filters. SR900 — How to Copyright © 2016 by The S.E.A. Group...
  • Page 4 Fit the respirator on your face. Cover the centre hole in the pre-filter holder with the palm of your hand. Breathe in and hold your breath for about ten seconds. SR900 — How to Copyright © 2016 by The S.E.A. Group...
  • Page 5 Wear your breathing hose There are two types of breathing hose: single and twin. Most SR900 configurations can use either the single or twin hose. You can use the hose as is, but if your work involves heat, sparks or open flames, you may choose to cover the hose with a protective flame-resistant cover.
  • Page 6 The same procedure applies to both the single 1/4 turn and the twin hose. To remove the hose, turn it anticlockwise and pull out the hose connector. 1/4 turn SR900 — How to Copyright © 2016 by The S.E.A. Group...
  • Page 7 To remove the hose from the device, turn the connector anticlockwise and pull out. IMPORTANT: Before using the SR900 respirator with any of the devices listed above, make sure you are familiar with the device and know how to use it correctly. Please consult the appropriate training modules for the respective device.
  • Page 8 IMPORTANT: Before using the SR900 respirator with the SR307 supplied-air regulator, make sure you are familiar with the regulator and know how to use it correctly. Please consult the SR307 training modules. Use the Remote Filter Holder The remote filter holder lets you wear the filter around your back on a waist belt.
  • Page 9 Remote Filter Holder and turn ¼ turn clockwise until it locks into position. 1/4 turn Fit a single or twin breathing hose between the SR900 respirator and the Remote Filter Holder, fit the mask to your face and tighten the waistbelt. Prepare for use in welding The remote filter holder is ideal for use in welding.
  • Page 10 — a simple procedure that takes only a minute. Cleaning may be done with warm soapy water and a soft cloth, or by using Sundstrom’s special sterilised hygienic cleaning tissues that keep your mask soft and flexible.
  • Page 11 If the headstrap is very dirty, detach it, clean and dry separately before re-attaching. Tip: use a toothbrush to clean the strap. Watch this on (using your SmartPhone, tablet or computer) https://youtu.be/hlO-wpwjzC8 SR900 — How to Copyright © 2016 by The S.E.A. Group...