Settings Guide; Settings For Different Materials - Technotape HPM.MFS.350.002 Instruction Manual

SETTINGS GUIDE

SETTINGS FOR DIFFERENT MATERIALS

WARNING!
The following settings are for reference only. Please,
always test your materials before production to find
the correct settings suited for your product.
Material
Ceramic/Glass Mug
Water Bottle
(Aluminum or Stainless Steel)
Plastic Mug
F.A.Q.
The transferred image is a little too light.
First, lengthen the sublimation time. If that doesn't work, raise the
temperature with 3°C. The last option is to give the press more
pressure.
The transferred image is a little too vague.
Reduce the sublimation time with 10 seconds.
The transferred image is not brilliant.
Reduce the pressure or reduce the temperature.
The transferred image is partial vague.
The sublimation paper did not make contact with the product
completely. Usually this means that the surface of the product is
not completely smooth.
The paper is sticky.
The temperature is either too high or the sublimation paper is of
poor quality.
The edges of the mug color brown.
Reduce the sublimation time with 20 seconds.
Technotape International
Tolweg 7
3741 LM Baarn
The Netherlands
Temp. Time
180 °C
120 sec.
360 °F
180 °C 35 - 45
360 °F sec.
170 °C
120 sec.
340 °F
+31 (0)35 541 80 94
+31 (0)35 541 18 17
office@technotape.com
www.technotape.com
Notes
1. Print on suitable sublimation paper.
2. Place the mug in the correct orientation to avoid breaking the handle.
1. Print on suitable sublimation paper.
2. Take off the the lid before pressing.
3. Use low pressure settings.
1. Print on suitable sublimation paper.
2. Use low pressure settings.
8