OPERATING THE PRESS
REPLACING HEAT MATS
Step by step
Turn off the press, loosen the screw
and remove the connection cable.
Hold and press the heat element
to release it from the screws. Use
both hands on the two sides of the
element.
Line up the four screws with the four
holes, and place the heat element.
Fix the cable with the rubber hook.
Loosen the four screws above the
heat element.
Slowly remove the heat element.
Tighten the four screws.
Now you have installed a different
heat element so you can print mugs
with a different size or shape.
Unlock the hook and remove the
cable.
Hold and press the heat element you
want to place. Use both hands on the
two ends to place it.
Connect the cable to the controller by
inserting it and fastening the screw
6