How To Use - Panasonic ER-SP20 Operating Instructions Manual

Notes
• Recommended ambient temperature for charging is
10 °C – 35 °C. It may take longer to charge, or the charge
status lamp ( ) will blink quickly and the battery may fail to
charge properly in extremely high or low temperatures.
• 1 full charge will provide approximately 70 minutes of
continuous operation. (Based on dry using at 20 °C – 30 °C)
The operating time may differ depending on the frequency of
use and the operating method.
• When charging the main body for the first time or when it has
not been in use for more than 6 months, the charging time
may change or the charge status lamp (
a few minutes. It will eventually glow if kept connected.
• If there is noise from the radio or other sources while using
or charging the appliance, move to a different location to use
the appliance.
• Charging each time does not affect battery life, because it
uses a lithium‑ion battery.
• The battery will deteriorate if not used for over 6 months, so
make sure to perform a full charge at least once every 6 months.
• To keep charging the battery will not affect battery performance.
Charging without the charging stand
Plug the AC adaptor into the main body and the
household outlet.
AC operation
If you connect the AC adaptor to the appliance in the same
way as for charging, and turn on the power, you can use it.
• If the remaining battery is too low, the blades may move
slowly or stop, even with the AC operation. In this case,
charge the battery for 1 minute or more.
• The battery will be discharged, even with the AC operation.

How to use

• Check that the blades are not damaged or deformed before use.
• The appliance may not operate in an ambient temperature
lower than approximately 5 °C.
• Clean and apply the lubrication oil to the blade after use.
Turn on the power, trimming.
• The desired results may not be achieved if hair
is too long.
In this case, trim the hair shorter (about 0.3 mm)
) may not glow for
before using the appliance.
►About the approximate remaining charge
High battery
Notes
• The lamps will turn off approximately 5 seconds after
operating the switch. However, if the battery remaining is
low, it will not turn off and one battery capacity lamp and the
charge status lamp blinks. (When the power is turned off, the
lamps turn off after 5 seconds.)
Charging is required when the one battery capacity lamp and
the charge status lamp blinks. You can trim 5 minutes after
this is displayed. (This will differ depending on usage.)
• The charge status lamp (
capacity
( :Glows,
) glows when using AC operation.
Low battery
capacity
/ :Blinks, / :Turns off)
9