Electromagnetic Compatibility (Emc) - NURIS MIG 550 RWS Operational Manual

ELECTROMAGNETIC COMP ATIBILITY (EMC)
This machine has been designed in accordance with all relative directives and norms.
However, it may still generate electromagnetic disturbances that can affect other
systems like telecommunications (telephone, radio, and television) or other safety
systems. These disturbances can cause safety problems in the affected systems. Read
and understand this section to eliminate or reduce the amount of electromagnetic
disturbance generated by this machine.
Before installing the machine, the operator must check the work area for any devices
that may malfunction because of electromagnetic disturbances. Consider the
following:

Input and output cables, control cables, and telephone cables that are in or
adjacent to the work area and the machine,

Radio and/or television transmitters and receivers,

Computers or computer-controlled equipment,

Safety and control equipment for industrial processes,

Personal medical devices like pacemakers and hearing aids,

Equipment for calibration and measurement.

Check the electromagnetic immunity for equipment operating in or near the
work area.
compatible. This may require additional protection measures.

The dimensions of the work area to consider will depend on the construction of
the area and other activities that are taking place.
If any electromagnetic disturbances are detected the operator must put in place
corrective actions to eliminate these disturbances. Consider the following guidelines to
reduce electromagnetic emissions from the machine:

Connect the machine to the input supply according to this manual. If
disturbances occur if may be necessary to take additional precautions such as
filtering the input supply.

The output cables should be kept as short as possible and should be
positioned together.

If possible, connect the work piece to ground to reduce the electromagnetic
emissions. The operator must check that connecting the work piece to
ground does not cause problems or unsafe operating conditions for personnel
and equipment.

Shielding of cables in the work area can reduce electromagnetic emissions. This
may be necessary for special applications.
The operator must be sure that all equipment in the area is
iii
08/2022 Rev. 1.3