Table of Contents
Advertisement
2.3 Disassembly
To disassemble the turn plate, proceed as in sub-section .1.1 Mounting the turn plate on the
90/130P trolley, but in the reverse order.
3 Use
3.1 Operating instructions
The turn plate functions are controlled from the motor control box. The
motor control box functions vary depending of the end effectors used
together with the turn plate. The joystick controls the variable rotation
speed of the turn plate. The turn plate has endless rotation angle.
4 Safety
The maximum load must not be exceeded (max-load, se heading 6
Technical specifications). The trolley and the end effectors may not be used for lifting people. The
operator is asked to be aware of the risk of injury that exists when raising or lowering the end
effector. Avoid putting your arm through the handlebar when trying to get hold of or pick up
something from the end effector. The operator must always be aware of not holding his hands or
other parts of his body under a hanging load.
Always lower the end effector to the lowest possible level that the circumstances at ground level
allow for, before any transport of goods is attempted. The load shall always be centered and stand
as close to the column as possible in order to provide maximum stability. Be especially careful
when passing over thresholds, door steps, cables and other
4.1 Storage and transport
When transporting and storing the turn plate attached to a lift-trolley, the power cable between
the lifters power pack and the motor control box must be unplugged.
The trolley is only intended for in-door use and on flat plain ground.
5 Maintenance
To ensure that your Turn device will function at its best it is important to give it regular
maintenance as specified below
3
Advertisement
Table of Contents
