Dometic CDF2 Operating Manual page 20

Operation
Fixing with the safety seat belt
➤ Proceed as shown (fig. 9, page 7).
Fixing with luggage tighteners
➤ Proceed as shown (fig. 0, page 8).
6.7 Selecting the temperature unit
➤ Proceed as shown (fig. a, page 8).
6.8 Setting the temperature
➤ Proceed as shown (fig. b, page 8).
6.9 Setting the display's brightness
➤ Proceed as shown (fig. c, page 9).
I
NOTE
• The factory setting of brightness of the display is d0 (default).
• If a fault occurs, the brightness automatically reverts to brightness d0
(default). After troubleshooting the set brightness is reactivated.
6.10 Using the battery monitor
If the cooler is operated when the vehicle ignition is switched off, the cooler switches
off automatically as soon as the supply voltage falls below a set level. The cooler will
switch back on once the battery has been recharged to the restart voltage level.
A
NOTICE! Danger of damage
When switched off by the battery monitor, the battery will no longer be
fully charged. Avoid starting repeatedly or operating current consumers
without longer charging phases. Ensure that the battery is recharged.
In "HIGH" mode, the battery monitor responds faster than at the levels "LOW" and
"MED" (see the following table).
Battery monitor mode
Switch-off voltage at 12 V
Restart voltage at 12 V
20
LOW MED
10.1 V 11.4 V
11.1 V 12.2 V
CDF236
HIGH
11.8 V
12.6 V
EN