Table of Contents
Advertisement
INSTALLATION
Installation Flow Chart
The installation of Input Disconnect configurations for Aquavar CPC drives follows the outline
below. The steps must be carried out in the order shown. At the right of each step are refer-
ences to the detailed information needed for the correct installation of the unit.
NOTE! References in the middle column below are to the Aquavar CPC User's Manual
(IM167). References in the third column below are to this manual.
Task
PREPARE for
installation
PREPARE the
Mounting
Location
REMOVE the
front cover
MOUNT the drive
INSTALL wiring
CHECK installation
REINSTALL the
cover
APPLY power
START-UP
6
Refer to the
Aquavar CPC User's Manual
"Installation" Section
"Preparing for Installation"
"Prepare the Mounting Location"
"Remove Front Cover"
"Mount the Drive"
"Wiring Overview" and
"Install the Wiring"
"Check Installation"
"Reinstall Cover"
"Apply Power"
"Start-Up"
Additional Reference
in this Manual
• R7/R8: "Lifting the Drive"
on page 7.
• "Drive Identification" on page 8.
• "Suitable Mounting Location"
on page 9.
• R7/R8: "Prepare the Mounting
Location – R7 and R8" on
page 9.
• "Dimensions and Weights
(Supplement to Aquavar CPC
User's Manual)" on page 27.
R7/R8: "Remove Side Panel- R7 and
R8 NEMA 1 and 12 Enclosures" on
page 9.
R7/R8: "Mount the Drive" on
page 10.
"Installing the Wiring (Supplement
to Aquavar CPC User's Manual)"
starting on page 10.
—
—
—
—
Advertisement
Table of Contents
