Kenwood KNA-DV3100 Installation Manual page 7

Attaching Remote Control Sensor
When using a TV monitor other than ones
manufactured by KENWOOD, attach the Remote
Control Sensor following the procedure below:
1
Remove the backing paper from the double-sided
tape and attach the tape to the back of the
Remote Control Sensor.
2
After wiping off the dirt or oil from the attachment
location, attach the Remote Control Sensor.
NOTE
• Wipe off the dirt or oil from the surface to which
the Sensor is attached.
• Avoid locations under direct sunlight or near the TV
monitor where signals from the remote controller
are not received easily.
Reverse detection wire (Pink)
TEL mute wire (Brown)
Automatic illumination control wire (Orange)
Ignition wire (Red) 12 V
Battery wire (Yellow) 12 V
Ground wire (Black) - (To car chassis)
Connect to the TEL mute terminal
for the navigation system of the
TEL MUTE
KENWOOD car audio.
NOTE
If no connections are made, do not let the wire
come out from the tab.
ILLUMI
ACC
Car fuse box
To reverse lamp harness of car
REVERSE
To car light control switch
Ignition key switch
Car fuse box
(Main fuse)
Battery
Backing paper
Double-sided
tape
English
-7