Connection - Kenwood DNX-710 Installation Manual

Connection

Ignition key
switch
Car fuse box
(Main fuse)
C
+
–
Battery
connect either to the control terminal of the motor antenna, or to the
power terminal for the booster amplifier of the film-type antenna.
|
4
DNX7100
If you connect the ignition wire (red) and the battery
wire (yellow) to the car chassis (ground), you may
cause a short circuit, that in turn may start a fire. Always
connect those wires to the power source running
through the fuse box.
ACC
A
B
Car fuse box
Connect to the vehicle's parking brake
detection switch harness using the
supplied relay connector.
Parking sensor wire (Light Green)
PRK SW For the sake of safety, be sure to connect the parking sensor.
To vehicle's reverse lamp harness
To car light control switch
Connect to the terminal that is grounded when either
the telephone rings or during conversation.
Depending on what antenna you are using,
When using the optional power amplifier,
connect to its power control terminal.
To "EXT.AMP.CONT. " terminal of the amplifier
having the external amp control function.
If no connections are made, do not let the cable come out from the tab.
Ignition wire (Red)
A
Battery wire (Yellow)
B
Ground wire (Black) -
(To car chassis)
C
To steering remote
External amplifier control wire (Pink/Black)
FUSE ( 5A )
Antenna Cord
Reveres sensor wire (Purple/White)
Dimmer control wire (Orange/White)
Steering remote control input (Light
Blue/Yellow)
Mute wire (Brown)
Motor antenna control wire (Blue)
Power control wire (Blue/White)