Table of Contents
Advertisement
4. Installing the Camera
4.4.Adjust the Lens
1) Loosen the lock screw.
2) Rotate the enclosure to adjust the pan angle; rotate the camera to
adjust the tilt angle.
3) Tighten the lock screw to clamp the lens.
4.5.Install the Trim Ring
1) Attach the trim ring to the camera.
2) Rotate the trim ring clockwise to secure it to the camera.
For detailed instructions of further configuration, please refer to the user
manual of network camera.
4.1.Dissembling the Trim Ring
Rotate the trim ring
counterclockwise to remove itfrom the camera.
4.2.Drill the Holes
1) Attach the supplied drill template to
the position where you want to fix thecamera.
2) Drill the screw holes and the cable
hole on the ceiling according to the drill template.
There are two cable outlet methods.
One is to route the cables through thecable hole,
and the other is to routethe cables through the si
de outletshown below.
4.3.Install the Camera
1) Connect the corresponding power/video cables.
2Insert the supplied screws to the screw holes.
3) Tighten the screws to secure the camera to the
ceiling.
Advertisement
Table of Contents
