Table of Contents
Advertisement
11. Turn the screw (M) Fig. 17 clockwise until it bottoms to prevent the vertical work-support plate (F) from accidentally being
moved into the blade. Tighten the nut (L).
12. Loosen the screw (Y) Fig. 19, and adjust the pointer (Z) to the "1/8" mark on scale.
F
L
Fig. 17
OPERATIONAL CONTROLS AND ADJUSTMENTS
Disconnect the Machine from the Power Source!
1. For rapid adjustment of the work support plate (A) Fig. 19, toward or away from the saw blade, loosen levers (B) and (C)
and move jig (D). Tighten levers (B) and (C).
2. You can fine-adjust the work support plate (A) Fig. 19, by loosening the lever (B) and rotating the knob (E) until plate (A)
is at the desired position. Tighten the lever (B) Fig. 19.
3. To tilt the vertical work support plate (A) Fig. 19, loosen the lock lever (F), tilt vertical work support plate to the desired
angle, and tighten lock lever (F).
4. To adjust backstop (G) Fig. 20, for angle tenons, loosen lock lever (H), tilt backstop (G) to the desired angle and
tighten lever (H).
IMPORTANT: The tenoning jig is not equipped with a bevel scale for the positioning of the backstop (G) Fig. 20 or the support
plate (A) Fig. 19. Cut the workpiece to the desired angle prior to the jig set up and use it as the angle reference.
A
F
D
Fig. 19
OPERATION
E
C
M
Fig. 18
G
B
Fig. 20
8
Y
Z
H
Advertisement
Table of Contents
