Advertisement
Available languages
Available languages
2 . Specifications:
System Voltage: 12V
Input voltage range: Analyzing Capacity(Amps): 9V~15V
CCA
100~2000
EN
100~2000
IEC
100~1400
DIN
100~1400
JIS
(100~2000 CCA)
Power Requirements: No internal batteries required. Power on when
hooked up during testing.
Application: Use to test a wide range of 12V batteries (Starting [SLI], Deep
Cycled and Marine) of Wet (Flooded), VRLA or Maintenance Free (MF),
Sealed Maintenance Free (SMF), Absorption Glass Mat (AGM) and GEL
cell. The major battery standards JIS, SAE, EN, DIN and IEC are supported.
3. Safety Measures:
For safety reasons, read this manual thoroughly before operating the
Tool.
Always refer to and follow the safety instructions and testing procedures
provided by the car or equipment manufacturer. The safety messages
presented below and throughout this user's manual are reminders to the
operator to exercise extreme care when using this test instrument.
Safety Precautions:
•
This battery analyzer is meant for testing of 12 Volts batteries only.
•
Its operating voltage is from 9V ~ 15V DC and should not be tested on
•
24V directly. It will cause damage the unit. For 12V x 2 batteries
(in series or parallel), disconnect the connections and test them
individually.
•
Battery that has just been charged by the charger contains surface
22
Advertisement
