GE GTH20SBBSS Owner's Manual & Installation Instructions page 17

REMOVE THE FREEZER DOOR
1
A
Tape the door shut with masking tape.
B
Remove the hinge cover on top of the freezer door
(on some models).
C
Using a 5/16" socket ratchet/driver, remove the two screws,
then lift the hinge straight up to free the hinge pin from
the socket in the top of the door.
Top Hinge
D
Remove the tape and tilt the door away from the
cabinet. Lift it off the center hinge pin.
E
Set the door on a non-scratching surface with
the inside up.
2 REMOVE THE
REFRIGERATOR DOOR
A
Tape the door shut with masking tape.
B
Using an adjustable wrench remove the center hinge
pin from the hinge bracket.
Hinge Pin
C
Remove the tape and tilt the door away from the
cabinet. Lift the door straight off the bottom hinge
bracket.
D
Set the door on a non-scratching surface, with the
inside up.
CAUTION: Do not let door drop to the floor.
To do so could damage the door stop.
Installation Instructions
TRANSFER TOP HINGE TO
3
THE LEFT
A
Remove the plug covers at top left side using the
edge of a thin flat blade to gently pry the plug off.
Cover the blade with tape to prevent scratching
the paint. You will assemble the plug covers in to
the right side.
B
Transfer hinge and screw on top right to the
top left of cabinet.
Do not tighten screws on hinge side at this time.
TRANSFER BOTTOM HINGE
4
BRACKET TO THE LEFT
A
Using a 5/16" socket ratchet/driver, move the
bottom hinge bracket from the right side to the
left side.
B
Move the hinge pin to the other hinge bracket hole
and the lower screw to the side hole.
NOTE: Make sure the spacer is between the cabinet
and the bracket hinge.
Spacer Hinge pin
17