Advertisement
3. R/G/B switch (at the top of the side panel) → G
Adjust for G-ch in the same manner.
(Adjustment Item: G)
4. R/G/B switch (at the top of the side panel) → B
Adjust for B-ch in the same manner.
(Adjustment Item: B)
Triming File Store
1. S1-5/IF-569 board → ON
2. AUTO button (Iris control block)/MSU-700
→ ON (lit)
3. MSU menu operation:
. PAINT button → ON (lit)
. Touch panel operation
(Page 1/3) → [Flare] → [Clear] → [|||Flare|||]
Message "Triming file stored" will be displayed
three seconds.
Resetting after Adjustment
. S1-5/IF-569 board → OFF
. Y/RGB switch (at the top of the side panel) → Y
. TEST 2 button/MSU-700 → OFF (dark)
HDC-750A
4-7-5. Check of Gamma Balance
Equipment: Analog waveform monitor
Test Point: TEST OUT connector
Preparations
. Connect the waveform monitor to the TEST OUT
connector of the unit.
. Setting for MSU-700
TEST1 button → ON (lit)
Adjustment Procedure
. Check that the level does not change even if the gamma
is turned on and off using the GAMMA OFF button on
the MSU-700.
If the level changes, readjust the gamma balance refer-
ring to Section 4-5-2.
4-7. Overall Video Adjustment
4-17 (E)
Advertisement
